Intrinsic hydrophobicity of smectite basal surfaces quantitatively probed by molecular dynamics simulations

M Szczerba and AG Kalinichev and M Kowalik, APPLIED CLAY SCIENCE, 188, 105497 (2020).

DOI: 10.1016/j.clay.2020.105497

The siloxane surface of uncharged clays is known to be hydrophobic, which is supported by strong experimental and theoretical evidence. For the siloxane surface of charged clays, like smectites, the picture is not as clear. We are aiming to clarify this issue by molecular simulations in which smectite surface hydrophobicity is quantified through the separate contribution of the surface itself, and the contribution due to the presence of charge-balancing cations on the surface. In order to explore systematically the effects of the total smectite charge and its distribution in the structure, a series of molecular dynamics (MD) simulations was performed for several models of dioctahedral smectites and compared with the results for uncharged pyrophyllite. The largest difference between the simulation results for smectite models with naturally present surface counterions and the models where these ions were artificially removed from the surface, while maintaining the same total charge balance of the model, is in the shape of the water coverage. In the former case, full surface wetting is observed and a relatively flat water film is forming on the surface. Its irregularity and thickness is connected with number of ions on the surface. However, in all cases of smectite surfaces artificially devoid of ions, a water droplet is always formed and the wetting is incomplete. The contact angles of the water droplets on charged montmorillonites are very similar to that on uncharged pyrophyllite surface and range roughly between 110 degrees and 90 degrees. These angles are also affected by the distribution of the octahedral and tetrahedral substitutions in the structure and by their ratio. In the case of purely tetrahedral substitutions the contact angle on the bare smectite surface can be as low as similar to 60 degrees, but still far from complete wetting. The angular distributions of the H2O dipole vectors as a function of distance from the smectite surface show two preferred surface-oriented types of water molecules when counterions are present, and the total surface is highly hydrophilic. However, for surfaces devoid of ions, a population with dipole angles close to similar to 90 degrees is dominating, and the smectite surfaces can be considered hydrophobic. It can be thus concluded that, independent of the structural charge, bare smectite surfaces by themselves are either hydrophobic or only moderately hydrophilic. Their experimentally observed highly hydrophilic character is almost entirely due to the charge balancing cations present on the surface.

Return to Publications page