Numerical Study and Experimental Validation of Deformation of FCC CuAl Single Crystal Obtained by Additive Manufacturing

AY Nikonov and AI Dmitriev and DV Lychagin and LL Lychagina and AA Bibko and OS Novitskaya, METALS, 11, 582 (2021).

DOI: 10.3390/met11040582

The importance of taking into account directional solidification of grains formed during 3D printing is determined by a substantial influence of their crystallographic orientation on the mechanical properties of a loaded material. This issue is studied in the present study using molecular dynamics simulations. The compression of an FCC single crystal of aluminum bronze was performed along the axis. A Ni single crystal, which is characterized by higher stacking fault energy (SFE) than aluminum bronze, was also considered. It was found that the first dislocations started to move earlier in the material with lower SFE, in which the slip of two Shockley partials was observed. In the case of the material with higher SFE, the slip of a full dislocation occurred via successive splitting of its segments into partial dislocations. Regardless of the SFE value, the deformation was primarily occurred by means of the formation of dislocation complexes involved stair-rod dislocations and partial dislocations on adjacent slip planes. Hardening and softening segments of the calculated stress-strain curve were shown to correspond to the periods of hindering of dislocations at dislocation pileups and dislocation movement between them. The simulation results well agree with the experimental findings.

Return to Publications page