Micro-mechanical response of ultrafine grain and nanocrystalline tantalum

W Yang and CJ Ruestes and ZZ Li and OT Abad and TG Langdon and B Heiland and M Koch and E Arzt and MA Meyers, JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T, 12, 1804-1815 (2021).

DOI: 10.1016/j.jmrt.2021.03.080

In order to investigate the effect of grain boundaries on the mechanical response in the micrometer and submicrometerlevels, complementary experiments and molecular dynamics simulations were conducted on a model bcc metal, tantalum. Microscale pillar experiments (diameters of 1 and 2 mm) with a grain size of-100-200 nm revealed a mechanical response characterized by a yield stress of-1500 MPa. The hardening of the structure is reflected in the increase in the flow stress to 1700 MPa at a strain of-0.35. Molecular dynamics simulations were conducted for nanocrystalline tantalum with grain sizes in the range of 20-50 nm and pillar diameters in the same range. The yield stress was approximately 6000 MPa for all specimens and the maximum of the stress-strain curves occurred at a strain of 0.07. Beyond that strain, the material softened because of its inability to store dislocations. The experi-mental results did not show a significant size dependence of yield stress on pillar diameter (equal to 1 and 2 um), which is attributed to the high ratio between pillar diameter and grain size (-10-20). This behavior is quite different from that in monocrystalline specimens where dislocation 'starvation' leads to a significant size dependence of strength. The ultrafine grains exhibit clear 'pancaking' upon being plastically deformed, with an increase in dislocation density. The plastic deformation is much more localized for the single crystals than for the nanocrystalline specimens, an observation made in both modeling and experiments. In the molecular dynamics simulations, the ratio of pillar diameter (20-50 nm) to grain size was in the range 0.2-2, anda much greater dependence of yield stress to pillar diameter was observed. A critical result from this work is the demonstration that the important parameter in estab-lishing the overall deformation is the ratio between the grain size and pillar diameter; it gov-erns the deformation mode, as well as surface sources and sinks, which are only important when the grain size is of the same order as the pillar diameter. (c) 2021 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc- nd/4.0/).

Return to Publications page